FAQ

You bet.

Our products are 100% proudly Australian-made.

No short-cuts. Built to last.

Some products are priced on the website, but if you have further questions, or would like a unique job quoted, please call us on (07) 5499 1288, email zoe@bmfg.com.au, or fill in the online enquiry form.

Please note that we offer trade pricing on application.

We’re located in sunny Caboolture, roughly 45 minutes north of the Brisbane CBD.

You can absolutely collect your order from us, and we’re happy to assist with safe loading.

If collecting a shower cubicle, it should ideally lie face-down during transport on your Ute or small trailer. A packing blanket and straps will assist in safely securing your cubicle.

Right away if the requested product is in stock.

1-2 weeks if the product requires manufacturing

Or longer, if that suits the timing of your project better.

We deliver Australia-wide - metro and regional. We'll ship your fibreglass products wherever you need them.

The cost of delivery will differ based on product and delivery location. We can give you a quote prior to ordering.

Absolutely. We’re proud of our work and stand behind the quality of our products. We offer a 12-month warranty against faulty workmanship and materials.

To look after your fibreglass products, use a soapy cloth or sponge, or a soft bristled brush, with water, to clean them.

Please avoid:

• Abrasive cleaners
• Bleach
• Harsh chemicals etc.

Any accessories you add to your product (shower heads, taps etc) are covered by their respective manufacturer warranties.

One piece showers

• Have lower installation cost than any other shower system.
• Have fully waterproof one‑piece designs that greatly reduce the risk of leaks or water damage.
• Offer quick, simple installation with just timber battens and silicone.
• Are super easy to clean with no grout or mould—just wipe and go.

• Many models fit through tight spaces — like a standard 790 mm doorway, with some fitting openings as small as 500 mm.
• And if it doesn’t fit, we can be flexible — two‑ and three‑piece cubicles separate easily to navigate narrow halls or doorways.
• Even with tight access homes, you can still have a full‑size, premium fibreglass shower., with a high quality finish.

Read below, and watch the videos in the Product Information section of the website. If that doesn’t answer your question we’re only a phone call away.

• Structural integrity - our shower cubicles have their own structural integrity rated to 170kg. You do not need a bed of mortar or similar. All you need is a good thick bed of silicon-based adhesive to hold the shower down and remove the ‘drumminess’ from floor as you walk on it.
• Installation - All of our shower cubicles come with five flanges that sit at right-angles to your walls. By securing a simple timber baton (4x2 or similar) against your wall, the shower flanges can be attached to your batons using a good thick bead of silicon adhesive.
• Waterproofing - You do not need to waterproof under the shower. Just like a bath, all our showers are fully enclosed waterproof units.
• Waste outlet misalignment- if your existing waste outlet doesn’t line up, we can tell you how to make a very simple 130mm high timber base onto which the shower will be able to be placed. This allows for easy plumbing adjustments without modifying your concrete slab.

Ours can, yes. Our products are made from gelcoat, which can be repaired and restored to better than new condition.

Many fibreglass products however, especially those coming out of China, are made with an acrylic coat that cannot be repaired.