Beachmere Fibreglass – Shower Cubicles, Enclosures & Custom Fibreglass Products
At Beachmere Fibreglass, we specialise in durable, one-piece fibreglass shower cubicles and enclosures, as well custom-made fibreglass roofs for horse floats and RVs, hot rod car bodies, guards, and wind deflectors for truck bodies. Below are answers to some of our most commonly asked questions.
We believe there are four main advantages to installing a one-piece fibreglass shower cubicle. 1) The overall cost of installation will be far less than any other method of putting in a shower cubicle; 2) Because the shower cubicle is an enclosed waterproof unit, no additional waterproofing is needed and the risk of water damage is greatly reduced as compared to any other shower system; 3) Installation of the shower cubicle is very simple indeed. Essentially all you need is a few lengths of timber batons and a good silicon adhesive; 4) Cleaning the shower cubicle is far easier than cleaning mould build-up inherent to tiled shower walls. Just a wipe down with a soapy cloth is all you need.
We have a range of shower cubicles that will fit through a conventional internal doorway width that is no wider than 790mm. Some of our shower one-piece shower cubicles can fit through even smaller doorways as small as 500mm wide. We also offer two and three-piece fibreglass shower cubicles that can be separated to fit through narrow doorways or hallways—so you can still enjoy a spacious, high-quality shower enclosure.
Our pricing is shown on our website, or you can simply call us on (07) 5499 1288, email info@bmfg.com.au, or fill in the form at bmfg.com.au/products/shower-cubicles#contact.
All our fibreglass showers and enclosures are proudly manufactured in-house at our custom facility in Caboolture, Queensland.
We accept bank transfers and cash.
Yes. Our shower cubicles come with a 12-month warranty against faulty workmanship and materials. Accessories are covered by their respective manufacturer warranties.
Avoid abrasive cleaners. Just a soapy cloth is all you need to clean the walls.
Yes, we arrange delivery throughout Brisbane, Gold Coast, Sunshine Coast, across NSW, Melbourne, all major cities and towns up to Cairns and beyond. We also cater to clients further afield in regional Queensland and interstate.
Absolutely. We can assist with safe loading. The shower should ideally lie face down during transport on your Ute or small trailer. Bring one packing blanket and straps for securing it.
Yes, you're welcome to visit. While we don’t always have every size of shower cubicle in stock at all times, there will always be a range of units onsite for your inspection.
We try to keep most sizes in stock, but because we are the manufacturer of these showers, it usually only takes a week or two to make a new one if we are out of stock of a particular size.
No. All our shower cubicles have their own structural integrity rated to 170kg. All you will need is a good thick bed of silicon-based adhesive to hold the shower down and remove the ‘drumminess’ out of the show floor as you walk on it.
All of our shower cubicles come with five flanges that sit at right-angles to your walls. By securing a simple timber baton (4x2 or similar) against your wall, the shower flanges can be attached to your batons using a good thick bead of silicon adhesive.
No. This is one of the advantages of our one-piece fully moulded showers. Just like a bath, all of our showers are enclosed waterproofed units.
No. While all our shower cubicles essentially sit flush to the floor, we are able to instruct you on making a very simple 130mm high timber base onto which the shower will be able to be placed, allowing for easy plumbing adjustments without modifying your concrete slab.
If you need more information about our products or services please do not hesitate to contact us.